INFLUENCE OF LAP-SOLDERED JOINT GEOMETRICAL DIMENSIONS ON ITS STRESS DEFORMED STATE
Abstract
The paper presents results of the analysis pertaining to lap-soldered joint bearing capacity of parts having various length and thickness. It has been shown that difference in dimensions of connected parts makes a pronounced effect on stress deformed state of lap-soldered joints. It has been determined that there is an increase in working stresses along the edges of a lap in parts with larger length and smaller thickness that is caused by action of a bending moment.
About the Authors
V. K. Sheleg
Belarusian National Technical University
Belarus
Belarus
Yu. A. Tsumarev
Belarusian National Technical University
Belarus
Belarus
E. V. Ihnatova
Belarusian-Russian University
Belarus
Belarus
References
1. Tomilin, O. V., Zhuravlev, Y. A., Kiselev, O. S.(1987) Calculation of Stress Deformed State of Lap-Soldered Joint Using Finite Element Method. Avotomaticheskaya Svar- ka [Automatic Welding], 8, 18-20.
2. Nikitinsky, A. M., Gerasimov E. A., Pigalov S. A. (2005) Investigation of Lap-Soldered Joint Strength. Sva- rochnoye Proizvodstvo [WeldingEngineering], 6, 21-25.
3. Tsumarev Yu. A., Ignatova, E. V., Latypova, E. Yu. (2011). Comparative Evaluation of Lap-Soldered Joints Strength with Chamfered Edges. Svarochnoye Proizvodstvo [Welding Engineering], 11, 34-38.
4. Lashko, S. V., Lashko, N. F. (1988) Soldering of Metals. Moscow: Mashonistroyenie.
5. Feodosiev, V. I. (1970) Resistance of Materials. Moscow: Nauka.
Review
For citations:
Sheleg V.K., Tsumarev Yu.A., Ihnatova E.V. INFLUENCE OF LAP-SOLDERED JOINT GEOMETRICAL DIMENSIONS ON ITS STRESS DEFORMED STATE. Science & Technique. 2014;(2):52-56. (In Russ.)
Views:
689
Email this article 