PECULIAR FEATURES PERTAINING TO STRIP FORMATION FROM BAR
Abstract
The paper describes results of calculations and presents experimental substantiation of the dependence of a strip width being rolled out of a 10-mm diameter bar on its final thickness. It has been shown that the formation technology of thin steel strips out of a round bar makes it possible without any difficulties to obtain rolled products with the given cross-section dimensions due to proper selection of single drafting.
About the Authors
G. N. Zdor
Belarusian National Technical University
L. A. Isaevich
Belarusian National Technical University
S. V. Ivanitsky
Belarusian National Technical University
References
1. Громов, Н. П. Теория обработки металлов давлением / Н. П. Громов. – М. : Металлургия, 1978. – 359 с.
2. Целиков, А. И. Теория продольной прокатки / А. И. Целиков, Г. С. Никитин, С. Е. Рокотян. – М. : Металлургия, 1980. – 318 с.
Review
For citations:
Zdor G.N., Isaevich L.A., Ivanitsky S.V. PECULIAR FEATURES PERTAINING TO STRIP FORMATION FROM BAR. Science & Technique. 2010;(6):38-41. (In Russ.)
Views:
2550
Email this article 