STATE AND PROSPECTS FOR DEVELOPMENT OF QUICK PROTOTYPING TECHNOLOGIES IN INDUSTRY. (Part 2)
Abstract
Growth dynamics pertaining to country- and industry branch-wise application of additive technologies is presented in the paper. The paper contains application examples of these technologies with a view of rapid manufacturing. Specific concrete recommendations are proposed for quicker introduction of additive manufacturing technologies in domestic industry.
About the Authors
L. Kolesnikov
Belarusian National Technical University
Belarus
Belarus
G. Mangula
MCP Technology Center
Belarus
Belarus
V. Sheleh
Belarusian National Technical University
Belarus
Belarus
A. Iakimovich
Belarusian National Technical University
Belarus
Belarus
References
1. Литье по выжигаемым моделям / В. Банкрутенко [и др.] // САПР и графика. – 2007. – № 4.– С. 66–72.
2. Аддитивная революция и серийные детали для AIRBUS // Конструктор. Машиностроитель. – 2010. –№ 2. – С. 38–39.
3. Wohlers, T. Wohlers Report 2011, Wohlers Associates / T. Wohlers // Inc., Fort Collins, Colorado USA. – 2010. – 270 p.
4. Шишковский, И. В. Лазерный синтез объемных изделий / И. В. Шишковский // Сборник докладов Самарского филиала Физического института имени П. Н. Лебедева РАН. – Самара, 2010. – С. 2–38.
5. [Электронный ресурс] Режим доступа: www.mcp.by
6. Roadmap for Additive Manufacturing. Identifying the Future of Freeform Processing. – The University of Texas at Austin. – 2009. – 102 p.
Review
For citations:
Kolesnikov L., Mangula G., Sheleh V., Iakimovich A. STATE AND PROSPECTS FOR DEVELOPMENT OF QUICK PROTOTYPING TECHNOLOGIES IN INDUSTRY. (Part 2). Science & Technique. 2013;(6):8-16. (In Russ.)
Views:
1739
Email this article 