INVESTIGATION OF COATING DEPOSITION UNIFORMITY WITH ABRASIVE SUSPENSION SPRAYING ON CUTTING DISKS TAKEN AS EXAMPLE
Abstract
The paper considers a possibility to ensure uniformity of coating spraying on disk-type parts due to control of technological parameters of the process. It is shown that one of the possible ways to create coatings with uniform thickness (density of abrasive particle distribution) is to change expenditure of a material to be deposited (abrasive suspension) in time and according to the linear law.
About the Authors
M. G. Kiselev
Belarusian National Technical University
Belarus
Belarus
D. A. Stepanenko
Belarusian National Technical University
Belarus
Belarus
References
1. Епифанов, В. И. Технология обработки алмазов в бриллианты / В. И. Епифанов, А. Я. Песина, Л. В. Зыков. - М., 1982.-335 с.
2. Киселев, И. Г. Теоретическая оценка закономерностей распределения алмазных частиц по поверхности ограночного диска при их нанесении методом распыления / М. Г. Киселев, Д. А. Степаненко // Теория и практика машиностроения. - 2005. - № 1. - С. 34-38.
Review
For citations:
Kiselev M.G., Stepanenko D.A. INVESTIGATION OF COATING DEPOSITION UNIFORMITY WITH ABRASIVE SUSPENSION SPRAYING ON CUTTING DISKS TAKEN AS EXAMPLE. Science & Technique. 2006;(3):51-56. (In Russ.)
Views:
366
Email this article 