TURNING KINEMATICS WITH IMPOSITION OF ASYMMETRIC TOOL VIBRATIONS
Abstract
The paper considers turning kinematics of structural carbon and alloy steels with imposition of directed asymmetric cutting tool vibrations on a conventional cutting pattern which are created by a cam system. An influence of tool vibratory motion parameters on crushing process of flow chips has been determined in the paper. The paper contains an equation of tool motion and reveals an influence of asymmetric coefficient of tool vibration cycle on slice thickness and dimensions of chip elements.
About the Authors
S. S. Danilchyk
Belarusian National Technical University
Belarus
V. K. Sheleg
Belarusian National Technical University
Belarus
References
1. Konovalov, E. G. Ostsilliruyushchee tochenie / E. G. Konovalov, A. V. Borisenko. - Minsk : Akademiya nauk BSSR, 1960. - 32 s.
2. Vibratsionnoe rezanie metallov / N. I. Akhmetshin [i dr.] ; pod obshch. red. K. M. Ragul'skisa. - L. : Mashinostroenie, Leningr. otd-nie, 1987. - 80 s.
3. Zakharov, Yu. E. Poleznye vibratsii v mashinostroenii / Yu. E. Zakharov, V. T. Garbuzyuk. - Tula : Priokskoe knizhnoe izdatel'stvo, 1970. - 112 s.
4. Poduraev, V.N. Obrabotka rezaniem s vibratsiyami / V. N. Poduraev. - M : Mashinostroenie, 1970. - 350 s.
5. Lavrov, N. K. Zavivanie i droblenie struzhki v protsesse rezaniya / N. K. Lavrov. - M. : Mashinostroenie, 1971. - 88 s.
For citations:
Danilchyk S.S.,
Sheleg V.K.
TURNING KINEMATICS WITH IMPOSITION OF ASYMMETRIC TOOL VIBRATIONS. Science & Technique. 2013;(4):16-21.
(In Russ.)
Views:
1637