Diagnostics of Cutting Tool Condition at Lathes with Numerical Programmed Control in N on-Stationary Formation Modes
Abstract
The paper considers the method which makes it possible to evaluate wear intensity and determine ultimate wear condition of a cutting tool at lathes with numerical programmed control by changes in entropy coefficient of the size stability of machined parts. The system of tool diagnostics and some results of the experimental investigations are given in the paper.
About the Authors
I. A. Kashtalyan
Belarusian National Technical University
Belarus
Belarus
P. K. Jukovskiy
Belarusian National Technical University
Belarus
Belarus
References
1. Подураев В. Н. Автоматически регулируемые и комбинированные процессы резания. - М.: Машиностроение, 1977. - 304 с.
2. Kashtalyan I. A. Improvement of Manufacturing Software for Microprocessor Program Controllers // Micro and Precision Mechanics: Proceeding of the 41th International Colloquium. - Ilmenau, 1996. - V. 1. - P. 441 -444.
3. Ратмиров В. А. Управление станками гибких производственных систем. - М.: Машиностроение, 1987. - 272 с.
4. Каштальян И. А., Клевзович В. И. Обработка на станках с числовым программным управлением. - Мн.: Вышэйш. шк., 1989. - 271 с.
5. Новицкий П. В. Основы информационной теории измерительных устройств. - Л.: Энергия, 1968. - 248 с.
Review
For citations:
Kashtalyan I.A., Jukovskiy P.K. Diagnostics of Cutting Tool Condition at Lathes with Numerical Programmed Control in N on-Stationary Formation Modes. Science & Technique. 2003;(6):33-38. (In Russ.)
Views:
2344
Email this article 